© 2009 Schneider Electric All Rights Reserved
Instruction Bulletin
80043-740-01
02/2009
Peru, IN, USA
Replaces 80043-402-04
NC Standard and Hinged Trim Fronts
Installation onto an NQ or NF Panelboard
Classes 1640 and 1670
Retain for future use.
ENGLISH
Introduction This bulletin contains instructions for installing a Square D
®
brand
NC standard or hinged trim front onto a Square D brand NQ/NF panelboard
manufactured by Schneider Electric.
Safety Precautions
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Turn off all power supplying this equipment before working on or inside equipment.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
To Next Page
Loading...
