Hach sc200 - Page 665

© 2009 Schneider Electric All Rights Reserved2
NC Standard and Hinged Trim Fronts 80043-740-01
02/2009
ENGLISH
Contents
Tools Needed
A. NC26S through NC86S and
NC26F through NC86F fronts only—
Low Amp Standard Trim (1)
B. NC44VS through NC86VS and
NC44VF through NC86VF fronts only—
High Amp Standard Trim (1)
C. NC26SHR through NC86SHR and
NC26FHR through NC86FHR fronts only—
Low Amp Hinged Trim (1)
D. NC44VSHR through NC86VSHR and
NC44VFHR through NC86VFHR
fronts only—High Amp Hinged Trim (1)
E. 10-32 x 19/32-in. Self-threading screws
(Quantities vary by kit. See table below.)
F. 1/4-20 x 1-in. Screws
(Quantities vary by kit. See table below.)
G. 1/4-20 Spring nut
(Quantities vary by kit. See table below.)
NOTE: Contents not shown to scale.
A
B
C
D
E
F
G
Item
NC26 NC32 NC38 NC44 NC50 NC56
TypeQtyTypeQtyTypeQtyTypeQtyTypeQtyTypeQty
E
S/F 4 S/F 4 S/F 6 S/F 6 S/F 6 S/F 6
S/FHR4S/FHR4S/FHR6S/FHR6S/FHR6S/FHR8
F/G
S/FHR4S/FHR4S/FHR4S/FHR4S/FHR4S/FHR4
——————VS/F8VS/F8VS/F8
——————VS/FHR8VS/FHR8VS/FHR8
Item
NC62 NC68 NC74 NC80 NC86
Type Qty Type Qty Type Qty Type Qty Type Qty
E
S/F 8 S/F 8 S/F 10 S/F 10 S/F 10
S/FHR 8 S/FHR 8 S/FHR 10 S/FHR 10 S/FHR 10
F/G
S/FHR 4 S/FHR 4 S/FHR 4 S/FHR 4 S/FHR 10
VS/F 8 VS/F 8 VS/F 8 VS/F 8 VS/F 10
VS/FHR 8 VS/FHR 8 VS/FHR 8 VS/FHR 8 VS/FHR 10
S = Surface mounted HR = Hinged right
F = Flush mounted V = Vented
.
• #2 Square-head Robertson screwdriver
• Slotted- or Philips-head screwdriver