© 2009 Schneider Electric All Rights Reserved 3
80043-740-01 NC Standard and Hinged Trim Fronts
02/2009 Installing Low Amp Standard Trim
ENGLISH
Installing the Trim Front
Installing Low Amp Standard Trim
Turn off all power supplying this equipment before working inside the panelboard; follow all lockout/tagout procedures.
The trim may be too heavy for one person to install. Additional assistance may be required.
1
Place the support bracket located at the bottom
of the trim front on the enclosure lip, as shown.
Support bracket
2
Open the trim front door. Align the screw holes
in the trim front door recesses with the screw
holes in the panelboard deadfront and fasten
with the 10-32 x 19/32-in. self-threading screws,
included in the kit.
NOTE: For flush-mounted applications, elevate
the interior to the proper position. Refer to the
information manual provided with the
panelboard for more information.
To Next Page
Loading...
