Hach sc200 - Page 680

Model 6 Motor Control Centers 80459-641-01E
List of Figures 10/2012
© 1999–2012 Schneider Electric All Rights Reserved8
ENGLISH
Figure 106: PowerPact L-frame Instantaneous Trip Adjustment ............74
Figure 107: PowerPact P-frame Instantaneous Trip Adjustment ............74
Figure 108: Typical Cabling Scheme for Modbus
®
Two-Wire .................77
Figure 109: Typical Cabling Scheme for DeviceNet™ and CANopen
(8A cable) ............................................................................78
Figure 110: Typical Cabling Scheme for PROFIBUS ..............................79
Figure 111: Motor Logic Plus Communication Module Terminals ...........82
Figure 112: TeSys T Controllers .............................................................87
Figure 113: NEMA Rated Control Unit (TeSys T Modbus) .....................87
Figure 114: Typical Arc-Rated Label Locations on Sections and Units ..92
Figure 115: Shelf and Door Installation ...................................................95
Figure 116: Midshelf for Arc-Rated MCCs ..............................................95
Figure 117: Cutting the Vertical Wire Trough Grommet (when supplied) 96
Figure 118: Removing the Manual Bus Shutter ......................................96
Figure 119: Engaging the Cam Mechanism ............................................96
Figure 120: Handles Flush with the Front of the MCC ............................96
Figure 121: Tightening the Control Unit Lock-in Panel (when supplied) .97
Figure 122: Power Leads Connected to Power Terminals ......................97
Figure 123: Connecting Control Leads to the Terminal Blocks ...............97
Figure 124: Pull-apart Terminals .............................................................98
Figure 125: Typical Unit Torque Label ....................................................98
Figure 126: Fuse Bases ..........................................................................98
Figure 127: Reinstalling the Compac 6 Control Unit ...............................99
Figure 128: Circuit Breaker Replacement .............................................111
Figure 129: Aligning the Arrows on the Panels .....................................113
Figure 130: Right Panel (Side View) .....................................................114
Figure 131: Installing the Right Panel into the Rear Groove .................114
Figure 132: Fixed Horizontal Bus Barrier ..............................................115
Figure 133: Horizontal Bus Barrier Installation and Removal ...............116
Figure 134: Barrier Installed and Removed ..........................................116
Figure 135: Retrofit Kit Components .....................................................117
Figure 136: Remove Existing Brackets on the 15 in. (381 mm) Deep
MCC ...................................................................................118
Figure 137: 15 in. (381 mm) Deep MCC Retrofit Bracket .....................119
Figure 138: 20 in. (508 mm) Deep MCC Retrofit Bracket .....................120
Figure 139: Endcap Placement .............................................................120
Figure 140: Horizontal Bus Barrier (L-shaped) Bracket ........................121
Figure 141: Welded and Relay Topshelf Assemblies ...........................121
Figure 142: Right Panel (Side View) .....................................................122
Figure 143: Installing the Right Panel into the Rear Groove .................122
Figure 144: Aligning the Arrows on the Panels .....................................123
Figure 145: Location of Auto-Shutter Cover for Side-Panel Opening ...124
Figure 146: Automatic Vertical Bus Shutter in an MCC (front view) .....125
Figure 147: Shelf Installation—Style 1 ..................................................126
Figure 148: Automatic Vertical Bus Shutter Installation—Style 1 .........126
Figure 149: Automatic Vertical Bus Shutter Removal—Style 1 ............127
Figure 150: Shelf Installation—Style 2 ..................................................128
Figure 151: Automatic Vertical Bus Shutter Installation—Style 2 .........129
Figure 152: Automatic Vertical Bus Shutter Removal—Style 2 ............130