SmartAXIS Touch User’s Manual 25-1
25
Data Transfer Function
This chapter describes the Project Transfer function to upload and download project data to the Touch using external
memory.
The function to exchange data using external memory is generically referred to as the Data Transfer function.
1.1 How the Project Transfer Function is Used
The project transfer function uploads or downloads project data between the Touch and an external memory inserted
in the Touch.
●
Download project data saved on an external memory to the Touch. However, you must create project
data for transfer.
● Upload the project data used for operation on the Touch and save it to an external memory.
1.2 Project Data Transfer Procedures
The following methods can be used to upload or download project data between the Touch and an external memory
inserted in the Touch.
• Using the USB Autorun function
F For details, refer to Chapter 26 “2 USB Autorun Function” on page 26-18.
• Using Key Buttons, Multi-Buttons, or Multi-commands
F For details, refer to “1.4 Using Key Buttons, Multi-Buttons, or Multi-Commands to Transfer Project Data” on
page 25-5.
Chapter 25 Data Transfer Function
1 Project Transfer Function
Create Project File
for Transfer
Download
TouchComputer
Project File
(ZNV Format)
USB flash drive
Project File
(ZNV Format)
Upload
Touch
USB flash drive
Project File
(ZNV Format)
When using the project transfer function and a project file is uploaded, the project file name is “project
name + file extension (.ZNV)”.
To Next Page
Loading...
