SmartAXIS Touch User’s Manual 9-99
7 Alarm Log Display
9
Data Displays
7.1 How the Alarm Log Display is Used
The Alarm Log Display displays Alarm Log data saved in the data storage area.
• List the message, the occurrence time, recovery time, and confirmation time for the alarms that have occurred
• Display the reference screen for alarms that have occurred
7 Alarm Log Display
Occurrence Message Recovered Confirmed
Fcs. Up Fcs. Dwn
Ref. REVERSE
12/01 12 : 00 Current fault 12 : 53 12 : 54
Touch
External device
Occurrence Message Recovered Confirmed
Fcs.Up Fcs.Dwn Ref. REVERSE
12/01 12 : 00 Current fault 12 : 53 12 : 54
0
1
12 : 00
0
1
12 : 53
12 : 00
Alarm occurred
12 : 53 Recovered
12 : 54 Confirmed
Recovery time
Confirmation time
Message
Occurrence time
Show focus Move focus
Key Button
Display reference screen
Time
09:15 Motor fault
Message
10:02 Pump1 fault
REV
Up
Dwn
Del
Ref.
10:28 High pressure
13:02 Pump 1 fault
Time
09:15 Motor fault
Message
10:02 Pump1 fault
REV
Up
Dwn
Del
Ref.
10:28 High pressure
13:02 Pump 1 fault
Time
09:15 Motor fault
Message
10:02 Pump1 fault
REV
Up
Dwn
Del
Ref.
10:28 High pressure
13:02 Pump 1 fault
Time
09:15 Motor fault
Message
10:02 Pump1 fault
REV
Up
Dwn
Del
Ref.
10:28 High pressure
13:02 Pump 1 fault
Pump 1 faultPump 1 fault
Pump 1 output low
Stop Start
Press Stop, check the air,
then press Start.
Air Press.
kg/m
2
0000
Reference screen
Only one Alarm List Display or Alarm Log Display can be configured on a single screen.
• For the key buttons used with the Alarm Log Display, refer to Chapter 7 “Alarm Log Display” on page 7-65.
•When the Operate the Alarm on List directly check box on the General tab in the Properties of Alarm
Log Display dialog box is selected, a displayed alarm can be given focus by pressing it on the list.
• The number of lines from the start line to the selected line of the message displayed on the Alarm Log
Display is stored in HMI Special Data Register LSD56.
To Next Page
Loading...
