IDEC SmartAXIS Touch FT1A Series User Manual

2 Operation Log Function Configuration Procedure
15-8 SmartAXIS Touch User’s Manual
This section describes the configuration procedure for the Operation Log function.
2.1 Configuring the Events and the Condition for Recording
1 On the Configuration tab, in the System Setup group, click Operation Log.
The Operation Log Settings dialog box is displayed.
2 Select the Enable Operation Log Settings check box.
3 Select the check boxes for the events to record under Target Events to record.
2 Operation Log Function Configuration Procedure
Power ON: The following items are recorded when the Touch power is turned on.
Time, screen number, event name
Switch to Base Screen: The following items are recorded when the Base Screen is switched.
Time, user name, screen number, event name, changed to
Change Users: The following items are recorded when the user is changed.
Time, user name, screen number, event name, changed to
Change Operation Modes: The following items are recorded when the operation mode is changed.
Time, user name, screen number, event name, changed to
Press buttons: The following items are recorded when a touch switch is pressed.
Time, user name, screen number, event name, part name
Write Data to any Devices: The following items are recorded when a value is written to a device by pressing a
touch switch.
Time, user name, screen number, event name, device, changed to

IDEC SmartAXIS Touch FT1A Series Specifications

General

Brand	IDEC
Model	SmartAXIS Touch FT1A Series
Category	Controller
Language	English