SmartAXIS Touch User's Manual 3-37
3 Project Settings Dialog Box
3
Project
3.6 O/I Link Tab
The O/I Link tab configures the slave stations to connect to when the Touch is used as the O/I Link Communication
master. It configures the O/I Link station when the Touch is used as a slave. For details, refer to Chapter 22 “2 O/I
Link Communication” on page 22-3. These options can only be configured when O/I Link Master or O/I Link
Slave is selected for Protocol under Interface Settings on the Communication Interface tab.
■ O/I Link Type
Selects the slave station (Slave1 to Slave15).
This option can only be configured when O/I Link Slave is selected for Protocol under Interface Settings on the
Communication Interface tab.
■ Slave Settings
Select the check boxes for the slave stations to connect to.
This option can only be configured when O/I Link Master is selected for Protocol under Interface Settings on
the Communication Interface tab.
The slave stations to connect to when the Touch is used as an O/I Link Communication Master are enabled
after the project is downloaded. The slave station number when the Touch is used as a slave is also enabled
after the project is downloaded.
To Next Page
Loading...
