8 USB Driver
A-18 SmartAXIS Touch User’s Manual
8.1 Installing the USB Driver
● Windows 7, Windows Vista
Follow these steps to install the USB driver.
1 Connect the USB cable to the USB interface on the Touch (with power supplied) and the USB port on the computer
(computer should be on).
8USB Driver
Before the Touch can be connected to a computer, it is necessary to install WindO/I-NV3 If you connect
Touch to the computer before installing the driver, an error message will appear prompting you to install
the driver software. In this case, clear the error and install the driver.
The USB interface supports both the 64-bit and 32-bit editions of Windows 7, and the 32-bit edition of
Windows Vista. It does not support the 64-bit edition of Windows Vista.
Touch
Computer
USB cable
A plug Mini-B plug
To USB port To USB interface
If running Windows Vista, the following dialog box appears.
Click Ask me again later.
To Next Page
Loading...
