IDEC SmartAXIS Touch FT1A Series User Manual

SmartAXIS Touch User’s Manual 13-9
1 Overview
13
Alarm Log Function
1.6 Using Data and Detected Alarms
The saved data and detected alarms can be used in the following ways.
●
Using Saved Data
The saved data can be used in the following ways.
●
Using Detected Alarms
• Display alarms with the Alarm List Display
Display detected alarms with the Alarm List Display.
For details, refer to “4.2 Displaying Registered Messages with the Alarm List Display According to the Active Alarm”
on page 13-27.
• Display data with the Alarm Log Display
Display Alarm Log data with the Alarm Log Display.
For details, refer to Chapter 9 “7 Alarm Log Display”
on page 9-99.
• Save to and read from an external memory
Alarm Log data is saved in a CSV file format into the
external memory which it can be read on your
computer.
For details, refer to “4.4 Saving Data as a CSV File”
on page 13-32.
To use with the Touch To use with devices other than the Touch
Alarm Log data
Ch.No. Message Occurrence Time Recovery Time Confirmation Time
1-1 Voltage drop 12/01/2011 12:00:05 12/01 12:01:10 12/01 12:01:30
1-2 Temperature abnormal 12/01/2011 12:01:09 12/01 12:02:21 12/01 12:02:55
1-1 Voltage drop 12/01/2011 12:02:00 12/01 12:03:11 12/01 12:05:12
1-3 Overcurrent 12/01/2011 12:30:21 12/01 12:55:15 12/01 13:00:00
1-1 Voltage drop 12/01/2011 12:45:36 12/01 12:53:12 12/01 12:57:41
Select Ref.
Occurred Message Recovered Confirmed
12/01 12:51 Temperature abnormal 12:53 12:52
12/01 12:00
Vo lt age dro p 12:53 12:52
Alarm Log data
(CSV)
Book1
Sheet1
Sheet2
Sheet3
Alarm List Display
Tou ch
External device
Voltage drop
Pg.
Up
Pg.
Dwn
0
1
Alarm occurred

IDEC SmartAXIS Touch FT1A Series Specifications

General

Brand	IDEC
Model	SmartAXIS Touch FT1A Series
Category	Controller
Language	English