SmartAXIS Touch User's Manual 28-5
3 Settings
28
Touch Setup
3.1 Initial Setting
Press Initial Setting on the Main Menu to display the initial setting screen. You can use this screen to input the
settings for Touch operation and communication parameters, and to clear the logs. To return to the Main Menu, press
Main Menu at the top of the screen.
●
System Op. (System Operation)
From the Main Menu, press Initial Setting, and then System Op. to display the system operation menu screen.
You can use this screen to set the items below. Press the button for each item to set it.
■ Backlight
This item sets the amount of time (in minutes) until the backlight turns off automatically when the screen is not
touched or switched for a preset amount of time.
From the Main Menu, press Initial Setting, System Op., and then Backlight.
To set a value, enter the value using the Keypad, and then press ENT.
Press CAN to cancel the entered value and display the currently set value.
■ Start Time
This item sets the amount of time (in minutes) until communication with the external device starts after Touch power
ON. This can be used to synchronize boot times with the external device.
From the main menu, press Initial Setting, System Op., and then Start Time.
To set a value, enter the value using the Keypad, and then press ENT.
Press CAN to cancel the entered value and display the currently set value.
3 Settings
• To return to the initial settings screen, press Init Set at the top of the screen.
• To return to the system operation menu screen from any of the settings screens below, press System
Op. at the top of the screen.
• The setting is not updated if you display another screen before pressing ENT.
• Setting a time of 0 turns off the backlight automatically.
The setting is not updated if you display another screen before applying the setting.
To Next Page
Loading...
