IDEC SmartAXIS Touch FT1A Series User Manual

4 Password Input
21-36 SmartAXIS Touch User’s Manual
When a password is configured for a user account, the user is prompted to enter their password with the following
operations.
• Accessing password protected data
• Executing password protected displays and operations
4.1 Entering the Password on the Touch
To execute password protected operations, the user must open the Password screen and switch the user account.
The Password screen is opened with a Goto Screen Button or Goto Screen Command configured with Password
Screen. The Password screen is also automatically displayed on the Touch when the following operations are
executed.
• Switching to a Base Screen for a security group that cannot be displayed by the current user account with the Goto
Screen Button, Multi-Button, Goto Screen Command, or Multi-Command when the Require a password
automatically check box is selected on the Options tab in the User Accounts dialog box
• Switching to Top Page in the System Mode or displaying the Device Monitor with the Maintenance screen, Goto
Screen Button, Multi-Button, Goto Screen Command, or Multi-Command
• Downloading or uploading project data with a Key Button, Multi-Button, or Multi-Command
• Executing the USB Autorun function
4Password Input
• Operations where the Password screen is not displayed are as follows.
- Switching the Base Screen using the System Area
- Displaying the alarm screen for the Alarm Log Settings
- Opening the keypad with the Numerical Input or Character Input
- Opening the Ref. screen with the Alarm Log Display
- For screens that are already open when the user account was switched by opening the Password screen
with the Goto Screen Button or Goto Screen Command
• When the user account is switched, the displayed Base Screen is reset. Popup screens and internal
devices have the same behavior as when the Base Screen is switched. However, if the Close while
changing Base Screen check box is selected on the Options tab in the Properties dialog box for the
popup screen, the popup screen is closed when the Base Screen is switched. The behavior of the internal
devices varies based on the internal devices. For details, refer to Chapter 27 “Internal Devices” on page
27-1.
• When the Touch has been installed vertically, the password screen is displayed horizontally.

IDEC SmartAXIS Touch FT1A Series Specifications

General

Brand	IDEC
Model	SmartAXIS Touch FT1A Series
Category	Controller
Language	English