SmartAXIS Touch User’s Manual 25-5
1 Project Transfer Function
25
Data Transfer Function
1.4 Using Key Buttons, Multi-Buttons, or Multi-Commands to Transfer Project Data
● Download
1
Create a project file for transfer (.ZNV) and save it on a USB flash drive.
For details, refer to “1.3 Converting Project Data for Transfer” on page 25-2.
2 Insert a USB flash drive in the Touch.
3 Press the Key Button or Multi-Button or execute the Multi-Command configured with Download Project under Data
Transfer on the Key Browser.
● Upload
1
Insert a USB flash drive in the Touch.
2 Press the Key Button or Multi-Button or execute the Multi-Command configured with Upload Project under Data
Transfer on the Key Browser.
Allocate a Key Button, Multi-Button, or Multi-Command configured with the project transfer function to the
Touch.
F For details, refer to Chapter 7 “4 Key Button” on page 7-49.
F For details, refer to Chapter 7 “5 Multi-Button” on page 7-68.
F For details, refer to Chapter 11 “5 Multi-Command” on page 11-31.
To Next Page
Loading...
