IDEC SmartAXIS Touch FT1A Series

SmartAXIS Touch User’s Manual 19-3
2 Text Groups and Text Configuration Procedure
19
Text Group
This section describes the configuration procedure for text groups and text.
2.1 Creating Text Groups
1 On the Configuration tab, in the System Setup group, click Text Group.
The Text Group Settings dialog box is displayed.
2 In Number of Text Groups, specify the number of text groups to create (1 to 16).
The configured number of text groups are enabled.
3 Under Text Group Name, enter the name for each text group.
The maximum number for the Text Group name is 20 characters.
For one text group, proceed to step
7.
2 Text Groups and Text Configuration Procedure