SmartAXIS Touch User's Manual 3-61
4 Special Functions
3
Project
● Procedure
To use the high-speed counter, a normal input must be specified as Two-phase High-speed Counter or Single-
phase High-speed Counter in the Function Area Settings tab. Inputs I0 to I7 on the Touch can be selected as
normal input, high-speed counter, catch input, interrupt input, and frequency measurement.
When using normal input, catch input, interrupt input, or frequency measurement, high-speed counter cannot be
used. The interrupt input can only be used when ladder program is selected as the programming language.
1 On the WindO/I-NV3 View tab, in the Workspace group, click (Control Function).
WindLDR starts.
2 On the WindLDR Configuration tab, in the Function Area Settings group, click Input & Output Configuration.
The Function Area Settings dialog box is displayed.
3
Select
Two-phase High-speed Counter
or
Single-phase High-speed Counter
for the group to use the high-speed counter.
The High-speed Counter Settings dialog box is displayed.
4 Configure the operation mode and the counting mode, and then click OK.
To use comparison actions, configure the comparison settings.
5 Click OK.
This concludes configuring the settings.
To Next Page
Loading...
Need help?
General
