2 Alarm Log Function Configuration Procedure
13-12 SmartAXIS Touch User’s Manual
The devices to monitor and the messages are batch configured and displayed in Settings of Alarm Log Settings
dialog box.
14
Click OK.
The Alarm Log Settings dialog box closes.
This concludes configuring the devices to monitor and the alarm detection condition.
Next, configure the functions to execute using saved data and detected alarms.
F “4.1 Displaying Saved Data with the Alarm Log Display” on page 13-25
F “4.2 Displaying Registered Messages with the Alarm List Display According to the Active Alarm” on page 13-27
F “4.3 Make a Sound of the Buzzer and Flash the Screen when an Alarm has Occurred” on page 13-30
F “4.4 Saving Data as a CSV File” on page 13-32
To Next Page
Loading...
Need help?
General
