4 Using the Data
14-36 SmartAXIS Touch User’s Manual
25
Specify the source device for the copied data in Display Device under Display Method.
For sequential devices of the amount of data to copy starting with Destination Device configured on the Options
tab on the Data Log Settings Individual Settings dialog box, set Display Device for each Numerical Display to those
devices.
Example: When Destination Device is LDR10, Number of Data is 3
Specify three Numerical Displays with Display Device specified as LDR10, LDR11 and LDR12
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-62.
26
Click OK.
The Properties dialog box closes.
27
Repeat step
17
through
26
to configure the Numerical Displays for the amount of data to copy.
This concludes configuring the Numerical Display.
Tou ch
External device
(Internal device)
124
125
126
Data Log data
Sampling Time Data001
01/01/2011 12:00:30 120
01/01/2011 12:01:30 121
01/01/2011 12:02:30 122
01/01/2011 12:03:30 123
01/01/2011 12:04:30 124
01/01/2011 12:05:30 125
01/01/2011 12:06:30 126
LDR10 : 126
LDR11 : 125
LDR12 : 124
Copy
To Next Page
Loading...
Need help?
General
