IDEC SmartAXIS Touch FT1A Series User Manual

SmartAXIS Touch User’s Manual 21-9
2 Security Function Configuration Procedure
21
User Accounts and the Security Function
3 Click Add.
The New User Account dialog box is displayed.
4 Specify the user number (1 to 15) in No.
This number is used when switching the user account according to the value of device.
5 Enter the name for the new user in User Name.
The maximum number for the user name is eight characters. Only alphanumeric characters and symbols can be used.
6 Enter the password in Password.
The number of characters for the password is 4 to 15. Only uppercase alphabetic characters and numbers can be
used.
7 Click the Group Membership tab.
Assign the security groups to the user being created.
Administrator, Operator, and Reader have already been provided in Security Group. These three security
groups cannot be used in multiple user accounts. To use them with the user account being created, delete the
security group from the user account they are assigned to beforehand.
If you will not add a new security group, proceed to step
11 .
If you will not assign a security group, proceed to step
12 .
You cannot use the following characters in the user name.
\ / : * ? “ < > |
Write down the password so you do not forget it and save that note in a safe place.
User3User2User1
Administrator AdministratorOperator
Reader

IDEC SmartAXIS Touch FT1A Series Specifications

General

Brand	IDEC
Model	SmartAXIS Touch FT1A Series
Category	Controller
Language	English