Korg NAUTILUS Series

AL-1: Tone Adjust 9–1: AMS Mixer
181
Mixer
• OSC 1 level (absolute)
• OSC 2 level (absolute)
• Sub OSC/Audio Input level (absolute)
• Ring Mod level (absolute)
• Noise level (absolute)
Filter A
In addition to the standard Tone Adjust filter parameters, the
AL-1 adds the following:
• Type (absolute)
• Cutoff (absolute)
• Resonance (absolute)
• Frequency EG Intensity (absolute)
• Frequency LFO Intensity (absolute)
Filter B
Filter B has the same Tone Adjust parameters as Filter A,
above.
Amp
• AMS 1 Intensity (absolute)
• AMS 2 Intensity (absolute)
• Drive (absolute)
• Low Boost (absolute)
EGs
In addition to supporting the standard Tone Adjust EG
parameters, the AL-1 adds the following separate controls
for both EG3 and EG4:
• Attack time (relative)
• Decay & Slope time (relative)
• Sustain level (relative)
• Release time (relative)
LFOs
In addition to supporting the standard Tone Adjust LFO
parameters, the AL-1 adds the following separate controls:
• LFO 3 Speed (relative)
• LFO 3 Fade (relative)
• LFO 3 Delay (relative)
• LFO 3 Stop (absolute)
• LFO 4 Speed (relative)
• LFO 4 Fade (relative)
• LFO 4 Delay (relative)
• LFO 4 Stop (absolute)
• LFO 1, 2, 3, and 4 Waveform (absolute)
• LFO 1, 2, 3, and 4 Shape (absolute)
Step Sequencer
In addition to supporting the standard Tone Adjust Common
Step Sequencer parameters, the AL-1 adds the following
separate control for the per-voice Step Sequencer:
• Smoothing (relative)
Pitch
• Pitch Slope (absolute)
• Pitch LFO AMS Intensity (absolute)