832
ROTOR
The rotor carries the low frequencies of the Rotary Speaker.
Its parameters are identical to those of the Horn, above.
Fast Speed [0…100]
Slow Speed [0…100]
Acceleration [0…100]
Deceleration [0…100]
Start Acceleration [0…100]
Stop Deceleration [0…100]
Balance and Tone
Horn/Rotor Balance [Rotor, 1…99, Horn]
Sets the volume balance between the high-frequency horn
and low-frequency rotor.
Speaker Simulator [Check-box]
Switches speaker simulation on/off.
Match CX-3 Tone [Off, Amp 1, Amp 2]
When using this effect on a CX-3 Program, this setting will
adjust the tone appropriately for the CX-3’s Amp Type. If
AmpType = Type1 or 2, use the corresponding Amp1 or 2
setting. If Amp Type = Pre Amp, turn this parameter Off.
MIC
These settings model two pairs of stereo microphones
recording the rotary speaker–one pair each for the horn and
rotor. In the real world, this would require an elaborate setup,
or even splitting the rotary speaker into two–but it’s
relatively easy in the software world of the NAUTILUS, and
it gives you separate control over the tone and stereo spread
of the high and low frequencies.
The other rotary speaker effects have only one pair of mics,
but are otherwise similar; for more information, see “MIC”
on page 829.
Horn Distance [0…100]
Horn Spread [0…100]
Rotor Distance [0…100]
Rotor Spread [0…100]
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
To Next Page
Loading...
Need help?
General
