Dell Force10 MXL Blade - Page 680

680 | Debugging and Diagnostics
www.dell.com | support.dell.com
Usage
Information
The buffer-profile global command fails if you have already applied a custom buffer-profile on an
interface. Similarly, when you configure buffer-profile global, you cannot not apply buffer-profile on
any interface.
If the default buffer-profile (4Q) is active, FTOS displays an error message instructing you to remove
the default configuration using the no buffer-profile global command.
You must reload the system for the global buffer-profile to take effect.
Related
Commands
buffer-profile (Interface)
Apply a buffer profile to an interface.
Syntax
buffer-profile profile-name
Parameters
Defaults
none
Command Mode
INTERFACE
Command
History
H
Related
Commands
show buffer-profile
Display the buffer profile that is applied to an interface.
Syntax
show buffer-profile {detail | summary} {csf | fp-uplink}
Parameters
Defaults
none
Command Mode
INTERFACE
Command
History
buffer (Buffer Profile) Allocates an amount of dedicated buffer space, dynamic buffer space, or
packet pointers to queues 0 to 3.
profile-name
Enter the name of the buffer profile you want to apply to the interface.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
buffer-profile (Configuration) Creates a buffer profile that can be applied to an interface.
detail
Display the buffer allocations of the applied buffer profiles.
summary
Display the buffer-profiles that are applied to line card port-pipes in the
system.
csf
Display the Switch Fabric Processor buffer profiles that you have applied to
line card port-pipes in the system.
fp-uplink
Display the Field Processor buffer profiles that you have applied to line card
port-pipes in the system.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module