C
HAPTER
39
| Multicast Filtering Commands
MVR for IPv4
– 1259 –
mvr This command enables Multicast VLAN Registration (MVR) globally on the
switch. Use the no form of this command to globally disable MVR.
SYNTAX
[no] mvr
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages.
If MVR must be configured for an IGMP version 1 host, the multicast
groups must be statically assigned using the mvr vlan group command.
EXAMPLE
The following example enables MVR globally.
Console(config)#mvr
Console(config)#
mvr
associated-profile
This command binds the MVR group addresses specified in a profile to an
MVR domain. Use the no form of this command to remove the binding.
SYNTAX
[no] mvr domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
DEFAULT SETTING
Disabled
show mvr interface Shows MVR settings for interfaces attached to the MVR
VLAN
PE
show mvr members Shows information about the current number of
entries in the forwarding database, or detailed
information about a specific multicast address
PE
show mvr profile Shows all configured MVR profiles PE
show mvr statistics Shows MVR protocol statistics for the specified
interface
PE
Table 162: Multicast VLAN Registration for IPv4 Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General
