C
HAPTER
5
| Interface Configuration
Trunk Configuration
– 184 –
trunk. This mode works best for switch-to-router trunk links where
traffic through the switch is received from and destined for many
different hosts.
■
Source and Destination MAC Address: All traffic with the same
source and destination MAC address is output on the same link in a
trunk. This mode works best for switch-to-switch trunk links where
traffic through the switch is received from and destined for many
different hosts.
■
Source IP Address: All traffic with the same source IP address is
output on the same link in a trunk. This mode works best for
switch-to-router or switch-to-server trunk links where traffic
through the switch is received from many different hosts.
■
Source MAC Address: All traffic with the same source MAC
address is output on the same link in a trunk. This mode works best
for switch-to-switch trunk links where traffic through the switch is
received from many different hosts.
PARAMETERS
These parameters are displayed for the load balance mode:
◆ Destination IP Address - Load balancing based on destination IP
address.
◆ Destination MAC Address - Load balancing based on destination MAC
address.
◆ Source and Destination IP Address - Load balancing based on
source and destination IP address.
◆ Source and Destination MAC Address - Load balancing based on
source and destination MAC address.
◆ Source IP Address - Load balancing based on source IP address.
◆ Source MAC Address - Load balancing based on source MAC address.
WEB INTERFACE
To display the load-distribution method used by ports in aggregated links:
1. Click Interface, Trunk, Load Balance.
2. Select the required method from the Load Balance Mode list.
3. Click Apply.
To Next Page
Loading...
