C
HAPTER
13
| Security Measures
Access Control Lists
– 361 –
◆ Time Range – Name of a time range.
WEB INTERFACE
To add rules to a Standard IPv6 ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select IPv6 Standard from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the source address type (Any, Host, or IPv6-prefix).
8. If you select “Host,” enter a specific address. If you select “IPv6-prefix,”
enter a subnet address and the prefix length.
9. Click Apply.
Figure 197: Configuring a Standard IPv6 ACL
To Next Page
Loading...
Need help?
General
