C
HAPTER
14
| Basic Administration Protocols
Link Layer Discovery Protocol
– 441 –
the other items and described under “Configuring LLDP Interface
Civic-Address.”
■
ECS ELIN – Emergency Call Service Emergency Location
Identification Number supports traditional PSAP-based Emergency
Call Service in North America.
◆ Country Code – The two-letter ISO 3166 country code in capital ASCII
letters. (Example: DK, DE or US)
◆ What – The type of device to which the location applies as described
for the field entry “Device entry refers to” under “Configuring
LLDP Interface Attributes.”
Port Details – Extended Power-via-MDI
7
◆ Power Type – Power Sourcing Entity (PSE) or Power Device (PD).
◆ Power Priority – Shows power priority for a port. (Unknown, Low,
High, Critical)
◆ Power Source – Shows information based on the type of device:
■
PD – Unknown, PSE, Local, PSE and Local
■
PSE – Unknown, Primary Power Source, Backup Power Source -
Power conservation mode
◆ Power Value – The total power in watts required by a PD device from
a PSE device, or the total power a PSE device is capable of sourcing
over a maximum length cable based on its current configuration. This
parameter supports a maximum power required or available value of
102.3 Watts to allow for future expansion. (Range: 0 - 102.3 Watts)
Port Details – Inventory
7
◆ Hardware Revision – The hardware revision of the end-point device.
◆ Software Revision – The software revision of the end-point device.
◆ Manufacture Name – The manufacturer of the end-point device.
◆ Asset ID – The asset identifier of the end-point device. End-point
devices are typically assigned asset identifiers to facilitate inventory
management and assets tracking.
◆ Firmware Revision – The firmware revision of the end-point device.
◆ Serial Number – The serial number of the end-point device.
◆ Model Name – The model name of the end-point device.
To Next Page
Loading...
