C
HAPTER
14
| Basic Administration Protocols
Remote Monitoring
– 477 –
To show configured RMON alarms:
1. Click Administration, RMON.
2. Select Configure Global from the Step list.
3. Select Show from the Action list.
4. Click Alarm.
Figure 271: Showing Configured RMON Alarms
CONFIGURING
RMON EVENTS
Use the Administration > RMON (Configure Global - Add - Event) page to
set the action to take when an alarm is triggered. The response can include
logging the alarm or sending a message to a trap manager. Alarms and
corresponding events provide a way of immediately responding to critical
network problems.
CLI REFERENCES
◆ "Remote Monitoring Commands" on page 795
COMMAND USAGE
◆ If an alarm is already defined for an index, the entry must be deleted
before any changes can be made.
◆ One default event is configured as follows:
event Index = 1
Description: RMON_TRAP_LOG
Event type: log & trap
Event community name is public
Owner is RMON_SNMP
PARAMETERS
These parameters are displayed:
◆ Index – Index to this entry. (Range: 1-65535)
To Next Page
Loading...
