F
IGURES
– 51 –
Figure 68: Creating Static VLANs 197
Figure 69: Modifying Settings for Static VLANs 198
Figure 70: Showing Static VLANs 198
Figure 71: Configuring Static Members by VLAN Index 201
Figure 72: Configuring Static VLAN Members by Interface 202
Figure 73: Configuring Static VLAN Members by Interface Range 202
Figure 74: Configuring Global Status of GVRP 204
Figure 75: Configuring GVRP for an Interface 205
Figure 76: Showing Dynamic VLANs Registered on the Switch 205
Figure 77: Showing the Members of a Dynamic VLAN 205
Figure 78: QinQ Operational Concept 207
Figure 79: Enabling QinQ Tunneling 211
Figure 80: Configuring CVLAN to SPVLAN Mapping Entries 212
Figure 81: Showing CVLAN to SPVLAN Mapping Entries 212
Figure 82: Adding an Interface to a QinQ Tunnel 214
Figure 83: Configuring Protocol VLANs 216
Figure 84: Displaying Protocol VLANs 216
Figure 85: Assigning Interfaces to Protocol VLANs 218
Figure 86: Showing the Interface to Protocol Group Mapping 218
Figure 87: Configuring IP Subnet VLANs 220
Figure 88: Showing IP Subnet VLANs 220
Figure 89: Configuring MAC-Based VLANs 222
Figure 90: Showing MAC-Based VLANs 222
Figure 91: Configuring VLAN Mirroring 223
Figure 92: Showing the VLANs to Mirror 224
Figure 93: Configuring VLAN Translation 224
Figure 94: Configuring VLAN Translation 225
Figure 95: Showing the Entries for VLAN Translation 225
Figure 96: Configuring MAC Address Learning 228
Figure 97: Configuring Static MAC Addresses 230
Figure 98: Displaying Static MAC Addresses 230
Figure 99: Setting the Address Aging Time 231
Figure 100: Displaying the Dynamic MAC Address Table 233
Figure 101: Clearing Entries in the Dynamic MAC Address Table 234
Figure 102: Mirroring Packets Based on the Source MAC Address 235
Figure 103: Showing the Source MAC Addresses to Mirror 235
To Next Page
Loading...
