C
HAPTER
18
| Using the Command Line Interface
CLI Command Groups
– 690 –
The access mode shown in the following tables is indicated by these
abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
PM (Policy Map Configuration)
VC (VLAN Database Configuration)
ERPS Configures Ethernet Ring Protection Switching for
increased availability of Ethernet rings commonly used in
service provider networks
1093
VLANs Configures VLAN settings, and defines port membership
for VLAN groups; also enables or configures private
VLANs, protocol VLANs, voice VLANs, and QinQ tunneling
1125
Class of Service Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight for each
priority queue, also sets priority for DSCP
1169
Quality of Service Configures Differentiated Services 1183
Multicast Filtering Configures IGMP multicast filtering, query, profile, and
proxy parameters; specifies ports attached to a multicast
router; also configures multicast VLAN registration, and
IPv6 MLD snooping
1203
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
1295
Connectivity Fault
Management
Configures connectivity monitoring using continuity
check messages, fault verification through loopback
messages, and fault isolation by examining end-to-end
connections between Provider Edge devices or between
Customer Edge devices
1319
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and
maintain the links to subscriber CPEs
1361
Domain Name Service Configures DNS services. 1373
Dynamic Host
Configuration Protocol
Configures DHCP client and relay functions 1383
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters and ND Snooping
1395
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
Table 44: Command Group Index (Continued)
Command Group Description Page
To Next Page
Loading...
Need help?
General
