IDEC SmartAXIS Touch FT1A Series

1 Monitoring with WindO/I-NV3
24-10 SmartAXIS Touch User's Manual
Saving Registered Device Addresses to Project Data as a Custom Monitor List
If registered device addresses are saved with project data as a list, then even when the project data is later
reopened, the device addresses can be called from the List to be reutilized.
1 Click Add to List.
The Device List Name Setting dialog box is displayed.
2 Enter a name for the custom monitor list.
The maximum number is 40 characters. Only alphanumeric characters and symbols can be used.
3 Click OK.
The custom monitor list is added to the List.
4 Saving project data.
The following characters cannot be used for names of custom monitor list.
\ / : * ? " < > |
If a project file is closed without saving, custom monitor lists will not be saved with the project data.