IDEC SmartAXIS Touch FT1A Series User Manual

3 User Accounts Dialog Box
21-34 SmartAXIS Touch User’s Manual
● Options Tab
These settings can only be configured when the Use Security functions check box is selected on the General tab.
■ Change User by Device
Select this check box to switch the user account according to the value of device.
The user account is specified by using the number on the General tab.
Example: When the trigger device is D0 and the default user is selected as User1
The user account switches according to the value of device.
■ Back to Default User
Select this check box to automatically switch to the default user when the Touch is unused for an extended period of
time.
(Trigger device): Specifies the word device to write the number.
Click to display the Device Address Settings dialog box. For the device address configuration
procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-62.
123
No.
User Name
User3
User2User1
(Default user)
0
User account
Value of Trigger device D0
Switch to default
user account
1
Switch to user
account no. 1
2
Switch to user
account no. 2
3
Switch to user
account no. 3
4
None
Action
User3 User3
User2User1 User1
The user account is not switched when the
value of device is a number not configured to
a user account or an invalid number.
If the value of device is 0,
the user is switched to the
default user.
After: Specify the time (0 to 60 minutes) to switch to the default user after the Touch is last used.
If 0 is set, the Touch switches back to the default user immediately, even if the user account was
changed.

IDEC SmartAXIS Touch FT1A Series Specifications

General

Brand	IDEC
Model	SmartAXIS Touch FT1A Series
Category	Controller
Language	English