JRC JUE-501 User Manual

5. How to use the Telephone/FAX
5-15
Chapter5 How to use the Telephone/FAX
Announced Forwarding
Announced Forwarding forwards an outside call to local terminals connected to the BDE after a talk
on internal call. The outside caller will wait until your conversation will end hearing the
suspension tone.
To use Announced Forwarding, press 0 * and the extension number during the communication. The
specified terminal will ring and you can talk with the forwarding destination on internal call. Press
the On hook button ( ) or place the Handset on the cradle after your internal call finished.
Then the forwarding destination and the outside caller will start talking.
Extension numbers of the JUE-501/JUE-251 are designated as follows.
Table 5.1.9b Allocated Extension Number
Device Allocated number
Handset 000
TEL1~TEL6 001~006
All TEL ports and Handset 099
ISDN (Set PBX-MSN. Refer to p6-43.) 401
IPTEL1~IPTEL9
(Release software at end of 2013 will support)
501~509
All 999
Example) Terminal telephone connected with TEL port 1….. 0 * +001→ internal call→ [On-hook]
To cancel forwarding mode, press * *+* * *.
Forwarding mode will be cancelled and return to [on communication status]
On communication screen
Press 0 * and the extension number(to be transferred).
Press 0 * 001 to transfer to the terminal telephone connected with
TEL port 1.
Press 0 * 401 to transfer the telephone connected with ISDN port.
Internal
TEL1
COMM(OUT)
Idle screen
The specified terminal will start communication with the outside call
.
The screen backs to the idle screen.
HDST-Voice
12m29s
COMM(OUT)
APAC E143.5
14:03 UTC
CS PS READY
On communication screen for Internal call
The specified terminal will ring and on communication screen for
internal call will be displayed after your party takes the phone. Press
the On hook button ( ) or place the Handset on the cradle, after
your internal call finished.

JRC JUE-501 Specifications

General

Brand	JRC
Model	JUE-501
Category	Marine Equipment
Language	English