JRC JUE-501 User Manual

6. Web Menu System
6-39
Chapter6 Web Menu System
6.5.2.2 Set Auto Answering the Telephone (PBX Screen)
To enter the PBX screen, open “Telephony” menu on the left [menu] panel and select “PBX”.
In this menu, user can set up auto answer. When auto answer is enabled, a fixed message (Please
dial 3 digits extension number.) is reproduced automatically. The main unit waits for input from the
caller for set time. If no input is recognized, the call will be forwarded to the default destination.
The extension number of JUE-501/JUE-251 is designed as Table 6.5.2.2a.
Device Extension Number
Handset 000
TEL1~TEL6 001~006
ALL TEL ports and Handset 099
IPTEL1 ~ IPTEL6
(Release software at end of 2013 will support)
501～506
ISDN 401
All 999
Display Contents
1) Control Validation of Auto Answer
2) Incoming Type Incoming service type (Voice/Audio) for adapting auto answer
3) Extension Number Default destination for forwarding a call when no input had been recognized
for “Limit Time”.
*The call will not be forwarded when the terminal doesn’t accept the service
type specified at “2) Incoming Type”
. Check your Telephony settings
(Sec.6.5.2.1).
4) Limit Time Waiting time for input from caller
5) SET Registers the setting contents
Table. 6.5.2.2a Extension Number JUE-501/JUE-251
Fig. 6.5.2.2a PBX Screen
Table. 6.5.2.2b Contents of PBX-Auto Answer
1)
2)
3)
4)
5)
NOTE
* Auto Answer function is not available when the land telephone can not handle DTMF.
* Auto Answer function answers the call even when the receiver is absent, and thus the
communication charge will be incurred.
* JRC is indemnified for any communication fee troubles using this function except as
outlined in the product warranty and by limitation of law.

JRC JUE-501 Specifications

General

Brand	JRC
Model	JUE-501
Category	Marine Equipment
Language	English