5. How to use the telephone/FAX
5-34
5.2.3 Forwarding a call to the other terminals
We have two ways to pass a call to the terminal telephones which connected to BDE. One is Quick
Forwarding and another is Announced Forwarding.
* Quick Forwarding is unavailable when Multi-Voice Function is enabled. In that case, use
Announced Forwarding. About Multi-Voice Function, refer to Appendix J.
To forward a call to outside call automatically, refer to [6.5.2.3 Set Telephone Supplementary Service
(p6-40)] or [7.9.2.3 Suppl. setting (p7-50)].
Quick Forwarding
Quick Forwarding forwards an outside call to local terminals connected to BDE without any talk on
internal call.
To use Quick Forwarding, press * * and the extension number during the communication. After you
heard the beep tone, put the receiver back in its cradle.
Announced Forwarding
Announced Forwarding forwards an outside call to local terminals connected to BDE after a talk on
internal call.
To use Announced Forwarding, press 0 * and the extension number during the communication. The
specified terminal will ring and you can talk with your crew on internal call. Put the receiver back in
its cradle after your internal call finished. Then your crew can talk with the outside caller.
Refer to table below for extension numbers of the JUE-501/JUE-251.
Table 5.2.5 Allocated Extension Number
Device Allocated number
Handset 000
TEL1~TEL6 001~006
All TEL ports and Handset 099
ISDN (Set PBX-MSN. Refer to p6-43.) 401
IPTEL1~IPTEL9
(Release software at end of 2013 will support)
501~509
All 999
Example) Transfer a call to TEL1 with Quick Forwarding…...* * +001+[On-hook]
Transfer a call to Handset with Announced Forwarding…...... 0 * +000
To cancel forwarding mode, press * *+* * *.
Forwarding mode will be cancelled and return to [on communication status]
To Next Page
Loading...
Need help?
General
