4-14
4.2.4 Setting satellite search
In this section, setting of Satellite search is explained. Select [3 Satellite] from [Top menu], and select
[1 Satellite] from displayed [Satellite] menu screen.
Current setting is displayed with * mark on its line head. To change it, move the cursor by ___
buttons, and press OK button (by selecting [Auto], suitable satellite is automatically chosen).
JUE-501/JUE-251 automatically acquires the satellite which is suitable for communication from
the ship and which has high-elevation. However, the acquisition may fail because of a blocking
due to affection of an antenna and a blockage. In this case, Handset shows “SEARCH NG” at
the lowest line of the Handset screen or the antenna icon starts blinking at the top line. Select
available satellite which is able to communicate and is not blocked.
Fig. 4.2.3b SEARCH NG status of Idle screen
Fig. 4.2.3a Flow of Satellite selection
* Although there is nothing wrong with JUE-501/JUE-251, selecting satellite makes some noise
on ADE.
4 Phoneb ook
READY
2 Spot Beam
Satellite display
Auto
*AMER W98.0
APAC E143.5
EMEA E25.0
Select with a cursor, and press OK button.
Then the screen is returned to Top menu.
APAC E143.5
14:03 UTC
SEARCH NG
* Handset will display the suitable satellites from the operating satellites.
AMER W98.0 (Americas satellite)
APAC E143.5 (APAC satellite)
EMEA E25.0 (EMEA satellite)
To Next Page
Loading...
Need help?
General
