JRC JUE-501 User Manual

Appendix H How to connect PPPoE Connection
H-1
Appendix H How to connect PPPoE Connection
H.1 About PPPoE Connection
JUE-501/JUE-251 provides PPPoE server. You can use the Inmarsat Standard IP/Streaming IP service
via PPPoE connection on your PPPoE client―PC or Router.
Set PPPoE server information listed below to your PPPoE client.
Parameter Configuration
User Name void
Password void
Authentication method “Any” or “CHAP”
NOTE
 Your PPPoE client has a possibility to receive invalid packets
from the internet because PPPoE
connection assigns the global IP address allocated from the inmarsat network directly on your PC
or router.
 WAN Filter is not applied for PPPoE connections.
 The PS connection is made by PPPoE client’s connecting/disconnecting action.
 APN settings for PPPoE Connection (APN name, APN username and password) are set
on the
“Network->WAN Profile” screen. WAN profile of “GUEST” user is applied for
PPPoE
connection. For more information, refer to [Sec.6.5.5.1 Set WAN Profile
] and [Sec. 6.5.4.1
Register Users].
When WAN profile is used, only standard IP service can be used. The streaming
IP service cannot be used in PPPoE connection even if the s
ervice type in WAN profile is set to
“Streaming Only”.[

AT command can be specified to the detailed option of PPPoE connection. When AT command is
specified, WAN Profile is not referred. Streaming IP service can be used by specifying AT
command. Please refer to Sec. H.5 for detailed.
 PPPoE connection on Streaming IP service is not available. Confirm that “Streaming only”
is not
assigned to the “GUEST” user’s WAN Profile.
 PPPoE connections always use Inmarsat Standard IP service even if WAN Selector
of
JUE-501/JUE-251 is enabled.

JRC JUE-501 Specifications

General

Brand	JRC
Model	JUE-501
Category	Marine Equipment
Language	English