7. Handset Menu System
7-46
7.9.2.1 Telephony setting （ MENU+ 9 +2 +1+1~8）
In this menu, the user can execute the various setting to communication ports (Handset, TEL1~6, and
ISDN) respectively. Select setting port by button and press OK.
Secret Code: Sets operation limit. This menu is not displayed when [8 ISDN] is selected at
[Telephony setting item selection screen].
“Enable” requires secret code to make an outside call from the terminal connected to the
port.
“Disable” doesn’t require secret code so that anyone can make an outside call from
the terminal connected to the port.
Voice Vol.: Sets volume of voice output. This menu is not displayed when [8 ISDN] is selected
at [Telephony setting item selection screen].
“Normal” sets normal volume and “High” sets loud volume.
Out Type/In Type: Sets Outgoing/Incoming service type (Voice /Fax/Audio). This menu is not
displayed when [1 Handset] is selected at [Telephony setting item selection screen].
“Voice” sets service type 4k AMBE service.
“Fax” sets service type Fax.
“Audio” sets service type 3.1 kHz Audio service.
“Voice/Fax” sets service type 4k AMBE service and Fax.
“Voice/Audio” sets service type 4k AMBE service and 3.1 kHz Audio service.
Out Call: Sets the permission/prohibition of originating a call.
“Enable” sets no limitation.
“AllowedNum” permits making a call only to the allowed phone numbers. The
allowed number list contains a maximum of four phone numbers. It also permits
making a call to a phone number which begins with the listed number. (Setting 0081
permits making a call to 0081xxxx.)
“Phonebook” permits making call to numbers registered in phonebook.
“Disable” denies all outgoing call
.
* Making internal call is always allowed.
In Call: Sets the call up time after a call arrived to main unit by the time (seconds) selection.
“Enable” rings when a call arrives on main unit.
“After Xs” rings after X seconds later since a call has arrived on main unit.
“Disable” rings no sound.
To Next Page
Loading...
