6. Web Menu System
6-64
6.5.5.3 Set Permanent Connection (Always Activate Screen)
To enter the Always Activate screen, open “Network” menu on the left [menu] panel and select
“Always Activate”.
Once Always Activate function is set enabled on this screen, JUE-501/JUE-251 automatically connect
and keep Standard IP Connection after the start-up (PS READY) of main unit. (This function will
reconnect PS connection when it detects the disconnection by any reason). The Standard IP
Connection connected by this function will never be disconnected by Auto disconnect function.
Up to three connections can be set as always-activated connections.
NOTE
• The PS Connection connected by this function never gets disconnected by Auto
Disconnect function.
• There is a possibility to get unexpected communication fee charged by sending and
receiving unexpected packet through the connection. Thus be careful to block an
unexpected packet by using Packet filter and modifying settings of the terminal etc.
• JRC is indemnified for any communication fee troubles using this function except as
outlined in the product warranty and by limitation of law.
• Distribution partner of SIM card might charge a communication fee by only connecting
and disconnecting Standard IP Connection.
• This function does not work when the selected profile doesn’t support Standard IP
connection as its service type.
• If you can not send a packet through this connection, disconnect the connection and
wait till it reconnects again. Then after that, try to send a packet again.
• Do not overlap IP address range setting of this function with Packet Detection Activate
function or Remote Activate function.
• This function connects only primary connection and does not connect secondary
connection automatically.
To Next Page
Loading...
Need help?
General
