4-6
4.1.3 Power ON
Before turning on the power, check the following;
• Check the obstacles between antenna and satellite.
• Check that SIM card is correctly set.
• Check that the breaker of inboard power supply is turned on.
• Check that the coaxial cable from ADE is connected to BDE, certainly.
• Check that the Handset is connected to BDE, certainly.
Power ON
Turn the “POWER” switch of the main unit to “ON”.
The READY LED on the front panel will light up in green and start blinking. After a while, the
ANTENNA lamp will start blinking and then both lamps will stop blinking and light green.
Although there is nothing wrong with JUE-501/JUE-251, turning on the switch makes some noise
on ADE.
Power OFF
Turn the “POWER” switch to “OFF”.
Then, the READY lamp begins blinking in orange color, while the power source disconnecting
process is carried out. After, the power source disconnecting process is completed, the power
supply is turned off.
Do not remove the power supply cable before the power source disconnecting process is
completed.
Fig.4.1.3a Power switch and LEDs of Main unit
To Next Page
Loading...
