JRC JUE-501 User Manual

5. How to use the Telephone/FAX
5-35
Chapter5 How to use the Telephone/FAX
5.2.4 Handling Call Waiting
You may hear a call waiting Indication during talking on the phone. The call waiting Indication tone
is two beeps every three seconds. To handle call waiting, the phone must have R key. R key can be
replaced by pushing hook button of the phone for short time. Enable / disable call waiting is
performed by Web setting (refer to [6.5.2.3 Set Telephone Supplementary Service (p6-40)]).
Follow the procedure below as desired.
5.2.5 Holding on the line
To hold a call on, the phone must have R key. R key can be replaced by pushing hook button of the
phone for short time.
Follow the procedure below as desired.
NOTE
The BGAN system supports only one Call Waiting at the same time.
Clear the current call, and accept the waiting call.
Press R
１
#, during the call waiting indication
is ringing.
Hold the current call, and accept the waiting call.
Press R 2 #, during the call waiting indication
is ringing.
To exchange the held call for the active call,
press R 2 #.
To clear the active call and back to the held
call, press R 1 #.
Ignore the waiting call.
Just ignore the waiting call indication (take no
action).
Reject the waiting call.
Press R 0 #.
Place a call on hold.
Press R 2 #, during the call is active.
Place the existing call on hold and establish a new call.
Press R and dial the second phone number followed
by #.
Example) Establishing new call to +81422-45-9xxx in
Japan
→
R 0081422459xxx #
Exchange held call for active call.
Press R 2 #.
Clear the active call and back to the held call.
Press R 1 #.
Clear the holding call (if no waiting call exists).
Press R 0 #.
These functions have not been supported yet.
A new version supporting them will be released at the end of March 2014.

JRC JUE-501 Specifications

General

Brand	JRC
Model	JUE-501
Category	Marine Equipment
Language	English