Korg NAUTILUS Series

EXi: EP-1 MDS Electric Piano
372
Wet/Dry [Dry, 1: 99…99:1, Wet]
Sets the balance between the “wet” processed sound and the
dry input. The default is Wet.
Note: When Mode is set to Chorus, the Intensity control is
the same as Wet/Dry.
Source [List of Dmod Sources]
Selects a modulation source for Wet/Dry.
Amount [–100…+100]
Sets the modulation amount for Wet/Dry.
EP Chorus
This is inspired by a rare chorus built into an early version of
a famous modified tine piano.
Speed [Hz] [0.10…10.00]
This controls the speed of the chorus’ LFO. The default is
1.96 Hz.
Source [List of Dmod Sources]
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the “Dynamic Modulation Source
List” on page 910.
Amount [–10.0…+10.0]
This controls the depth and direction of the Speed
modulation.
Depth [0…100]
This sets the depth of LFO modulation. The default is 55.
Source [List of Dmod Sources]
This selects a modulation source to control the Depth.
Amount [–100…+100]
This controls the depth and direction of the Depth
modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 370.
Vintage Flanger
A model of a truly classic analogue flanger. This amazing
stompbox’s bucket-brigade technology provides a sweeping,
whooshing sound, perfect for chords.
Speed [Hz] [0.10…10.00]
This controls the speed of the LFO. The default is 0.14Hz.
Source [List of Dmod Sources]
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the “Dynamic Modulation Source
List” on page 910.
Amount [–10.0…+10.0]
This controls the depth and direction of the Speed
modulation.
Depth [0…100]
Sets the depth of LFO modulation. The default is 71.
Source [List of Dmod Sources]
This selects a modulation source to control the Depth.
Amount [–100…+100]
This controls the depth and direction of the Depth
modulation.
Resonance [0…100]
This controls the intensity of the flanger effect, via feedback.
The default is 35.
Manual [1…100]
This adjusts the offset of the LFO sweep, effectively
increasing the center delay time of the chorus. The default is
35.
When Depth is set to the maximum of 100, this has no
effect.
Source [List of Dmod Sources]
This selects a modulation source to control the Manual
amount.
Amount [–100…+100]
This controls the depth and direction of the Manual
modulation.
LFO Reset Source [List of Dmod Sources]
This selects a modulation source to reset the LFO. You can
use this to re-start the flanger’s jet-like, rolling motion just
before a big power chord, for instance. This will be most
useful when the Speed is set relatively low.
Reset Offset Amount [0…100]
This controls the phase of the LFO when reset.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 370.
Red Compressor
Need to play clean chordal passages with smooth, even
dynamics? Then, look no further: this compressor is
modeled on a pedal whose clean sound made it hugely
popular. Perfect for pop and funk music.
Sensitivity [1…100]
This controls the amount of compression. Increasing the
value boosts lower level sounds, and raises the overall
volume. The default is 50.
To adjust the final volume, use the Output Level parameter.
Attack [1…100]
This controls the onset time of the compressor. The default is
25.
Level [0…100]
Compression reduces the overall gain of the signal. This
allows you to compensate for that effect, by boosting the
gain again at the output. The default is 50.