EXi PROGRAM > EP-1: Panel/IFX/Amp Insert Effects
373
OUTPUT
Wet/Dry [Dry, 1:99…99:1, Wet]
Sets the balance between the “wet” processed sound and the
dry input. The default is Wet.
Source [List of Dmod Sources]
Selects a modulation source for Wet/Dry.
Amount [–100…+100]
Sets the modulation amount for Wet/Dry.
VOX Wah
This effect is modeled on two legendary VOX wah pedals:
the V847 and the V848 Clyde McCoy model. Thanks to their
unique “throaty” tone, these are the only wah pedals that
many professionals will consider putting under their feet.
Played musically, they can make your melody lines cry like a
baby—or howl like a man possessed!
A great tonal trick is to find a “sweet spot” within the range
of the Wah pedal and then leave it there. This “stuck-Wah”
can be very effective when used tastefully, producing a
distinctive sound that will cut through any mix.
Type [V847, V848]
This selects the pedal model.
V847 has a rounder sound; V848 (the default) has a more
aggressive sound.
Open [1…100]
This sets the wah frequency when the pedal is up. The
default is 36.
Close [1…100]
This sets the wah frequency when the pedal is down. The
default is 40.
Mode [Pedal Wah, Auto Wah]
This controls the basic operation of the wah, and also
determines which parameters appear below.
Auto Wah makes the wah follow the input signal’s volume
envelope. This is the default.
Pedal Wah lets you control the wah frequency directly via a
modulation source, just like a wah pedal.
Pedal Wah
These parameters appear only when the Mode is set to Pedal
Wah.
Pedal Source [List of Dmod Sources]
This selects a modulation source to control the wah
frequency. The default is JS+Y, but you can also use a real
pedal if you have one connected!
Pedal Manual [1…100]
This sets the default value of the pedal, before the selected
modulation source is moved. Once the source has been
moved, Pedal Manual has no effect. The default is 84.
Auto Wah
These parameters appear only when the Mode is set to Auto
Wah.
Auto Sensitivity [0…100]
This sets the sensitivity of auto-wah. Increase the value if the
input signal is too low to sweep the wah. Reduce the value if
the input signal is so high that the sweep stops temporarily.
The default is 18.
Auto Attack [1…100]
This controls the reaction time of the auto-wah. The default
is 10.
Auto Polarity [Up, Down]
This controls whether the auto-wah sweeps from open to
closed, or from closed to open. The default is Up.
OUTPUT
Wet/Dry [Dry, 1:99…99:1, Wet]
Sets the balance between the “wet” processed sound and the
dry input. The default is Wet.
Source [List of Dmod Sources]
Selects a modulation source for Wet/Dry.
Amount [–100…+100]
Sets the modulation amount for Wet/Dry.
v
5–1: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
•PAGE →p.126
•MODE →p.126
To Next Page
Loading...
Need help?
General
