COMBINATION > Timbre Parameters 2–2: OSC
407
Max # of Notes [Dynamic, 1…16]
Dynamic is the default. With this setting, you can play as
many notes as the system allows.
1-16 lets you limit the maximum number of notes played by
the Timbre. Voices will still be allocated dynamically, up to
this maximum number. You can use this to:
• Model the voice-leading of vintage synthesizers, such as
the Polysix
• Control the resources required by the Timbre, so that
more voices can play on other Timbres
Max # of Notes applies only when the Program’s Voice
Assign Mode is set to Poly, or when Force Osc Mode has
been set to Poly. With Mono, it has no effect.
This setting does not limit the Unison Number of Voices.
For instance, if Max # of Notes is set to 6, and Unison
Number of Voices is set to 3, you can play up to 6 notes,
each with 3 Unison voices.
In double Programs, the Max # of Notes applies equally to
both OSC or EXi. For instance, if Max # of Notes is set to 4,
you can play up to 4 notes on each OSC/EXi.
Timbres 02…16
Here you can make voice assignment settings for timbres 2
through 16. The settings are the same as for timbre 1. See
“Timbre 01”.
v
2–2: Page Menu Commands
• Compare →p.112
• Write Combination →p.433
• Exclusive Solo →p.113
• Copy From Program →p.433
• PAGE →p.126
• MODE →p.126
To Next Page
Loading...
Need help?
General
