Korg NAUTILUS Series

PROGRAM mode: HD-1
40
The off and full-on positions of the half-damper work just
like a standard footswitch. In conjunction with the Enable
Half-Damper parameter, below, intermediate positions
allow a graduated control of sustain, similar to the damper
pedal of an acoustic piano.
Enable Half-Damper [On, Off]
When this is On (checked), Half-Damper pedals, normal
sustain pedals, and MIDI CC# 64 will all modulate the Amp
EG, as described below.
When this is Off (un-checked), the pedals and MIDI CC#64
will still hold notes as usual, but will not modulate the Amp
EG.
Half-Damper Pedal and Release Time
The amount of modulation depends on whether the Amp EG
Sustain Level is set to 0 (as is the case with most acoustic
piano sounds), or set to 1 or more. The modulation is
continuous, from 1x (no change) to 55 times longer; the table
below shows a selection of representative points.
Half-Damper modulation of Amp EG Release Time
1–1h: Play Page MS/WS/DKit Display
OSC1
[List of installed Play Page MS/WS/DKit Display]
This works in conjunction with the Home page’s Show
MS/WS/DKit Graphics menu command (and its
corresponding Global parameter) to control whether the
PROGRAM > Home page shows the overview/jump
parameters (the graphical envelopes, LFOs, etc.), or the
selected graphics.
If the Show MS/WS/DKit Graphics menu command is not
enabled, then the overview/jump parameters will be shown
regardless of the setting here.
If Show MS/WS/DKit Graphics is enabled (checked), then
this parameter takes effect. See also “Show MS/WS/DKit
Graphics” on page 113.
MS/WS/DK Names shows the names of Osc 1’s
Multisamples, Wave Sequences, or Drum Kit as part of the
overview/jump parameters.
If a graphic is selected, then the graphic will be shown
instead of the normal overview/jump parameters.
OSC2
[List of installed Play Page MS/WS/DKit Display]
This controls the PROGRAM > Home page display for Osc
2. It works the same as “OSC1,” above.
v 1–1: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy Oscillator →p.119
• Swap Oscillator →p.119
• PAGE →p.126
•MODE →p.126
CC#64
Value
Multiply Amp EG Release Time by…
If Sustain = 0 If Sustain = 1 or more
01x 1x
32 2.1x 2.1x
64 3.2x
3.2x
80 5.9x
96 22.3x
127 55x