GLOBAL > Drum Kit 5–3: Voice/Mixer
677
Compressor and gate-type effects:
• 002: Stereo Compressor
• 003: Stereo Expander
• 005: Stereo Limiter
• 009: Stereo Gate
• 010: Stereo Noise Reduction
Example: Gated Reverb
This is an example of applying a gated reverb to only a
specific snare sound. When using a gate effect on reverb,
you may not be able to control the gating timing correctly if
you use the extended reverberant sound to control the gate.
Normally, you will control the gate using sound from before
reverb is applied.
For the key for which you’ve selected the snare sample, set
Bus Select to IFX6. Also use FX Control Bus Select to
send the signal to FX Control Bus 1. In IFX7: Stereo Gate,
choose FX Control 1 as the Envelope Source. Now you can
use a signal other than the input (reverberant sound) to
control the gate.
Pan [Random, L001…C064…R127]
Specifies the panning for each key.
L001 places the sound at far left, and R127 places the signal
at far right. With a setting of Random, the drum sample will
be panned randomly at each note-on.
Send1 (to MFX1) [000…127]
Send2 (to MFX2) [000…127]
For each key, specify the send levels to master effects 1 and
2.
These settings are valid when Bus Select (5–3b) is set to L/R
or Off. If Bus Select is set to IFX1–12, the send level to
master effects 1 and 2 will be determined by the
PROGRAM, COMBINATION, or SEQUENCER mode
IFX– Insert FX page parameters Send1 and Send2 which
are located after the sound passes through IFX1–12.
v
5–3: Page Menu Commands
• Compare →p.112
• Write Drum Kit →p.691
• Copy Key Setup →p.691
• Swap Key Setup →p.691
• PAGE →p.126
• MODE →p.126
IFX6
101: Reverb Hall
IFX7
009: Stereo Gate
KEY: D3
(Snare)
Bus Select
: IFX6
Chain to
: IFX7
FX Control Bus: 1
Envelope Source
: FX Control 1
Gated Reverb Example
Bus Select
: L/R
(FX Control Bus1)
GLOBAL > Drum Kit
PROGRAM >Amp1/Driver1, IFX Routing, Use DKit Setting = On
To Next Page
Loading...
Need help?
General
