Korg NAUTILUS Series

MEDIA: Page Menu Commands Install EXs
727
5. Go to the MEDIA– Utility page.
6. Using the Drive Select menu at the bottom of the page,
select the USB storage device.
You may need to wait a few seconds after connecting the
device before it is recognized.
7. Open the folder containing the EXs data from step 2.
8. Select the file whose name ends in .exsins.
The “exsins” suffix stands for “EXS INStaller.” For instance,
an installer file might be named “EXs10.exsins.”
When a .exsins file is selected, the Load button changes to
read Install. Only one EXs can be installed at a time. If
Multiple Select is On, Install will be disabled.
9. Select Install EXs from the menu, or press the Install
button.
The system will check to confirm that the installation files
are valid, and that there is sufficient space on the SSD to
install the EXs. Next, a dialog box will appear:
Found installer for: [EXs name]
Space required: [nnn] MB
SSD1: [drive name] [nnn] GB available
10.Press Install to continue with the installation, or press
Cancel to stop without installing.
An “are you sure?” message will appear to confirm the
installation.
11.Press OK to continue with the installation, or press
Cancel to stop without installing.
The installation will then begin. This may take a while; a
progress bar shows the installation as it proceeds. Next, the
newly installed files will be verified.
After the verification has completed successfully, the
progress bar will disappear, and the installation is complete.
The EXs sample data itself is installed on an invisible,
protected part of the drive. To use the EXs, you’ll load its
associated files (.KSC, .PCG etc.); for the location of these
files, see the documentation of the specific EXs.
Using the newly installed EXs
To use the new EXs:
1. Load the newly installed .PCG and .KSC files.
Make sure to back up any sounds before over-writing them
in memory. You may need to free up sample RAM, or use
the “Clear” option when loading the .KSC. You can also load
specific sounds from the .KSC, make your own sub-sets of
its sounds, and automatically load the new samples at
startup. For more information, see:
GLOBAL “0–3: KSC Auto-Load” on page 640
GLOBAL “0–4: Sample Manage” on page 643
MEDIA mode menu command “Load .PCG” on page 703
MEDIA mode menu command “Load .KSC” on page 712
Authorization
If an authorization code is required, the EXs will work in
demo mode, fading in and out, until the code is purchased
and entered into the NAUTILUS. For more information, see
“GLOBAL > Options Info” on page 682.
Error messages
When installing, error messages may be displayed to
indicate problems, as described below.
“Error: invalid option file” means that the installation data is
corrupted. Copy the file to the USB media again, or if that
fails, download the data again.
“Error: not enough disk space for the installation” means
that the internal SSD is too full. Remove data from the SSD,
backing it up to USB media, in order to free up space.
Uninstalling EXs
Optional EXs may be uninstalled to reclaim space on the
internal drive(s). For more information, see “Uninstall EXs”
on page 692.