Korg NAUTILUS Series

Alternate Modulation Sources (AMS) Alternate Modulation Source (AMS) List
903
AMS Mixer1&2
These are the outputs of the oscillator’s AMS Mixers. For
more information, see “6–1: OSC 1 AMS Mix” on page 89.
Wave Seq AMS Out1&2
These are the modulation outputs of the oscillator’s Wave
Sequence. For more information, see “Modulating Program
parameters per step” on page 184 of the OG.
Pitch EG
This is the output of the Pitch EG, which is shared between
both oscillators. For more information, see “2–9: Pitch EG”
on page 58.
Filter EG
This is the output of the oscillator’s Filter EG. For more
information, see “3–4: Filter1 EG” on page 70.
Amp EG
This is the output of the oscillator’s Amp EG. For more
information, see “4–3: Amp1 EG” on page 79.
LFO1 &2
These are the outputs of the oscillator’s two LFOs. For more
information, see “5–1: OSC1 LFO1” on page 83.
Common LFO
This is the output of the Common LFO, which is shared by
all voices of both oscillators. For more information, see “5–
9: Common LFO” on page 87.
Filter Key Track
This is the output of the oscillator’s Filter Key Track
generator. For more information, see “3–2: Filter1 Mod.” on
page 65.
Amp Key Track
This is the output of the oscillator’s Amp Key Track
generator. For more information, see “4–2: Amp1 Mod.” on
page 76.
Common Key Track1&2
These are the outputs of the two Common Key Track
generators, which are shared between both oscillators. For
more information, see “6–9: Common KeyTrack” on
page 96.
EXi Common
EXi programs support all of the “Physical and MIDI
controllers,” as described on page 901, in addition to the
AMS sources below, plus any AMS sources provided by the
specific EXi instruments.
Common Step Seq
This is the output of the Common Step Sequencer, which is
shared by all voices of both EXi. For more information, see
“5–1: Common Step Seq” on page 136.
Common LFO
This is the output of the Common LFO, which is shared by
all voices of both EXi. For more information, see “5–2:
Common LFO” on page 139.
Common Key Track1&2
These are the outputs of the two Common Key Track
generators, which are shared between both EXi. For more
information, see “5–2: Common LFO” on page 139.
EXi AL-1
The AL-1 supports all of the “EXi Common” AMS sources,
in addition to the AMS sources below.
AMS Mixer1&2
These are the outputs of the two AMS Mixers. For more
information, see “6–1: OSC 1 AMS Mix” on page 89.
Step Sequencer
This is the output of the per-voice Step Sequencer. For more
information, see “8–1: Step Sequencer” on page 173.
EG1 (Filter), EG2 (Pitch), and EGs 3 & 4
These are the outputs of the four assignable EGs. For more
information, see “7–1: EG 1 (Filter)” on page 169.
Amp EG
This is the output of the dedicated Amp EG. For more
information, see “6–3: Amp EG” on page 166.
LFO1 …4
These are the outputs of the four assignable LFOs. For more
information, see “8–2: LFO 1” on page 175.
Filter Key Track and Amp Key Track
These are the outputs of the Filter and Amp Key Track
generators, respectively. For more information, see “5–3:
Filter Mod.” on page 239 and “6–2: Amp Mod.” on
page 243.
EXi CX-3
The CX-3 supports all of the “EXi Common” AMS sources,
in addition to the AMS sources below.
AMS Mixer1&2
These are the outputs of the two AMS Mixers. For more
information, see “6–1: OSC 1 AMS Mix” on page 89.
EXi STR-1
The STR-1 supports all of the “EXi Common” AMS
sources, in addition to the AMS sources below.
AMS Mixer1…4
These are the outputs of the four AMS Mixers. For more
information, see “6–1: OSC 1 AMS Mix” on page 89.
EG1 (Filter), EG2 (Pitch), and EGs 3 & 4
These are the outputs of the four assignable EGs. For more
information, see “7–1: EG 1 (Filter)” on page 169.
Amp EG
This is the output of the dedicated Amp EG. For more
information, see “6–3: Amp EG” on page 166.
LFO1 …4
These are the outputs of the four assignable LFOs. For more
information, see “8–2: LFO 1” on page 175.