R&S ZNB - Page 1364

Command Reference
R&S
®
ZNB/ZNBT
1364User Manual 1173.9163.02 ─ 55
Note: If the specified cal kit does not exist, it is created with the specified calibration
standard.
Suffix:
<Ch>
.
Channel number. This suffix is ignored because calibration kits
are channel-independent.
Parameters:
<ConnType> Connector type, one of the following identifiers:
N50, N75: N 50 Ω or N 75 Ω connectors
PC7, PC35, PC292: PC 7, PC 3.5 or 2.92 mm connectors
USER<no>: User-defined connectors UserConn1, UserConn2
SMA: User-defined connector type SMA ...
Note: This command only supports ZVR-compatible connector
types. For general definitions use [SENSe:]CORRection:
CKIT:<StandardType>.
<StandardType> Standard type. For reflection standards, the first character
denotes the gender, e.g.:
FOPEN, MOPEN: Open (f) or Open (m) standard.
For transmission standards, the first two characters denotes the
genders on both ends, e.g.:
FFSNetwork, MFSNetwork, MMSNetwork: Symm. network
(ff), symm. network (mf) or symm. network (mm) standard.
For a complete list of standard types refer to Standard types and
their parameters .
Parameter list String parameters to specify the configured standard
(<CalkitName>, <StandardLabel>) and numeric parameters
defining its properties. See Parameter list.
*RST: n/a
Example:
CORR:CKIT:N50:FOPEN 'ZV-Z21','',
0,1.8E+010,0.0151,0,0,0.22,-0.22,0.0022
Define the properties of the open (f) standard for the N 50 Ω
connector type contained in the ZV-Z21 calibration kit: Assign a
valid frequency range of 0 Hz to 18 GHz, an electrical length of
15.1 mm, 0 dB loss and define the polynomial coefficients of the
fringing capacitance as 0 fF, 0.22 fF/GHz, –0.22 fF/(GHz)
2
,
0.0022 fF/(GHz)
3
.
[SENSe:]CORRection:CKIT:INSTall <CalKitFile>
Loads cal kit data from a specified R&S ZVR cal kit file.
R&S ZVR/ZVABT Compatible Commands