R&S ZNB - 8.3.17 SYSTem Commands; 8.3.17.1 SYSTem:COMMunicate...

Command Reference
R&S
®
ZNB/ZNBT
1300User Manual 1173.9163.02 ─ 55
STATus:QUEStionable:PTRansition <BitPattern>
STATus:QUEStionable:INTegrity:PTRansition <BitPattern>
STATus:QUEStionable:INTegrity:HARDware:PTRansition <BitPattern>
STATus:QUEStionable:LIMit<Lev>:PTRansition <BitPattern>
Configures the positive transition filters of the QUEStionable... status registers. If a
bit is set, a 0 to 1 transition in the corresponding bit of the associated condition register
causes a 1 to be written in the associated bit of the corresponding event register.
See also Chapter 7.5.5, "Reset Values of the Status Reporting System", on page 775.
Suffix:
<Lev>
.
Selects one of the two QUEStionable:LIMit registers; see
"STATus:QUEStionable:LIMit<1|2>" on page 769.
Parameters:
<BitPattern> Range: 0 to 65535 (decimal representation)
*RST: n/a
Example:
STAT:QUES:LIM2:PTR 6
Set bits no. 1 and 2 of the
QUEStionable:LIMit2:PTRansition register
STATus:QUEue[:NEXT]?
Queries and at the same time deletes the oldest entry in the error queue. Operation is
identical to that of SYSTem:ERRor[:NEXT]?.
The entry consists of an error number and a short description of the error. Positive
error numbers are instrument-dependent. Negative error numbers are reserved by the
SCPI standard; see section Chapter 10, "Error Messages and Troubleshooting",
on page 1417.
Example:
STAT:QUE?
Query the oldest entry in the error queue. 0,"No error" is
returned if the error queue is empty.
Usage: Query only
8.3.17 SYSTem Commands
The SYSTem... commands provide functions that are not related to instrument perfor-
mance, such as functions for general housekeeping and functions related to global
configurations.
8.3.17.1 SYSTem:COMMunicate...
The SYSTem:COMMunicate... commands provide remote control settings and con-
figure remote (external) devices controlled by the R&S ZNB/ZNBT.
SCPI Command Reference