R&S ZNB - 8.3.19 TRIGger Commands; 8.3.19.1 TRIGger[:SEQuence]...

Command Reference
R&S
®
ZNB/ZNBT
1346User Manual 1173.9163.02 ─ 55
Usage: Setting only
8.3.19 TRIGger Commands
8.3.19.1 TRIGger[:SEQuence]...
The TRIGger[:SEQuence]... commands synchronize the analyzer's measurement
sequences to external events. These events are indicated to the VNA by sending trig-
ger signals via EXT TRIG IN or the USER PORT.
TRIGger<Ch>[:SEQuence]:HOLDoff.............................................................................. 1346
TRIGger<Ch>[:SEQuence]:LINK................................................................................... 1346
TRIGger<Ch>[:SEQuence]:MULTiple:HOLDoff................................................................1347
TRIGger<Ch>[:SEQuence]:MULTiple:SLOPe<Num>....................................................... 1347
TRIGger<Ch>[:SEQuence]:MULTiple:SOURce............................................................... 1348
TRIGger<Ch>[:SEQuence]:SLOPe................................................................................ 1349
TRIGger<Ch>[:SEQuence]:SOURce..............................................................................1349
TRIGger<Ch>[:SEQuence]:HOLDoff <DelayTime>
Sets a delay time between the trigger event and the start of the measurement ("Trigger
Delay").
Suffix:
<Ch>
.
Channel number.
Parameters:
<DelayTime> Delay time.
Range: 0 s to 13680 s
Increment: 10 ms
*RST: 0 s
Default unit: s
Example:
TRIG:SOUR MAN
Activate external trigger source.
TRIG:HOLD UP
Set a delay time of 10 ms.
Manual operation: See "Delay" on page 407
TRIGger<Ch>[:SEQuence]:LINK <MeasSequence>
Selects the triggered measurement sequence. The identifier for the sequence is a
string variable.
Suffix:
<Ch>
.
Channel number
Parameters:
<MeasSequence> Triggered measurement sequence, string variable.
SCPI Command Reference