R&S ZNB - SOURce:POWer... (Contd.)

Command Reference
R&S
®
ZNB/ZNBT
1287User Manual 1173.9163.02 ─ 55
SOURce<Ch>:POWer<PhyPt>:CORRection:TCOefficient:INSert<ListNo>
<Frequency>, <TransCoeff>
Inserts a new frequency and transmission coefficient at position no. <ListNo> in the
power loss list. The following points are shifted down in the list.
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the trans-
mission coefficient settings are valid for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the transmis-
sion coefficient settings are valid for all sources.
<ListNo> Number of point to insert in the list.
Parameters:
<Frequency> Stimulus frequency value. If several points with identical fre-
quencies are added, the analyzer automatically ensures a fre-
quency spacing of 1 Hz.
Range: Stimulus values outside the frequency range of the
analyzer are allowed.
*RST: n/a
Default unit: Hz
<TransCoeff> Transmission coefficient
Range: -300 dB to +200 dB
*RST: n/a
Default unit: dB
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection:
TCOefficient:CALibration
Manual operation: See "Frequency / Transm. Coefficients: Insert, Delete, Delete
All" on page 493
SOURce:POWer... (Contd.)
The SOURce:POWer... commands define the power of the internal signal source.
SOURce:POWer:GENerator:SDELay.............................................................................1288
SOURce:POWer:REDuce:SDELay................................................................................ 1288
SOURce:POWer:SWEepend:MODE.............................................................................. 1288
SOURce:POWer:SWEepend:SDELay............................................................................1289
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate][:AMPLitude]...................................... 1289
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:OFFSet............................................ 1290
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:SLOPe............................................. 1290
SOURce<Ch>:POWer<PhyPt>:CORRection:GENerator<Gen>:LEVel:OFFSet...................1291
SOURce<Ch>:POWer<PhyPt>:CORRection:LEVel:OFFSet............................................. 1292
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:OFFSet............................................... 1293
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:PERManent[:STATe]............................. 1294
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:STATe................................................. 1294
SOURce<Ch>:POWer<PhyPt>:PERManent[:STATe]....................................................... 1295
SOURce<Ch>:POWer<PhyPt>:REDuce[:STATe].............................................................1295
SCPI Command Reference